•  
    您好!歡迎來到我們的網站
    鎮江百靈船舶用品有限公司??
    24小時服務熱線:
    20年生產循環水處理
    0511-85728888
    為廣大用戶提供優質的產品和完善的服務
    Zhenjiang Bailing Ship Supplies Co., Ltd.?
    產品中心
    地址:鎮江市民營開發區
    公司網址:WWW.ZJBLCB.COM
    聯系電話:0511-85728888
    公司傳真:0511-85728028
    郵編:212111
    聯系我們
    你的當前位置為:
    903型強力除碳劑
        發布時間: 2019-08-05 09:23    




    903型強力除碳劑


    說明
    903除碳清潔劑是一種性質卓越滲透力強的溶劑?;旌掀渌鍧崉┖弯P蝕抑制劑等而成。專用以清除柴油機內各種活塞、活塞環、閥及其他零件等,在燃燒后所聚集的積垢、炭素、油漆和黏性物質。
    使用法
    903除碳清潔劑,能滲透沉積污垢、溶解油料、油脂、油漆及燃燒不完全的物質。又能使不能溶解的礦物質(炭、煙灰、灰垢、污物)軟化,以便揩擦清除。
    903除碳清潔劑又可用作清潔零件及整件機械之用。例如用作清洗油低、乳膠及環氧漆等極為有效。
    建議兩種清潔方法:
    A、浸洗法:
    1、除去橡膠附件。將待清潔的零件放入大小適度的盤或桶內。以除碳清潔劑浸過其表面,小零件則放置于鐵絲籃中,以便于去污及取出。
    2,浸洗時間,必須等待所有沉積污垢完全溶解或松脫為止(通常為4至8小時)。但其所需正確時間,須視積垢之厚度和性質而定。
    a.當沉積污垢過于嚴重時,需要不時攪動其溶劑。
    b.當沉垢已碳化,則溶劑須加熱至55℃—60℃(130˙F—140˙F),不可加熱至75℃(165˙F)以上。
    3,從清潔盆內取出,用水沖洗,以清除尚留存在零件上的酥松污物,然后用布抹干或用壓縮空氣吹干。
    B、擦洗法:
    重大機械在原地清洗,可用沾有除碳清潔劑的漆刷擦刷污處(勿用橡皮毛刷)。擦刷時,漆刷須常蘸有溶液,直至清潔為止。在擦刷時,空氣必須流通。清潔完
    畢用濕布揩抹,再用干布抹干。
    詳細的清潔程序可依據利用的器具,而由工程師隨意決定。
    處理
    在處理時,戴上護目鏡及塑膠手套??諝饬魍?,避免過久吸入蒸發氣體。如若意外的接觸皮膚,立即用水清洗。如液體意外的進入眼睛,即用水清洗,并送醫。
    包裝


    20KG/塑料桶


    貯存
    貯放處遠離煙火。


    ENGLISH


    903 Powerful Carbon Removal Agent 


    903 carbon Removal Agent is a best and strong solvent with high leakage ability, which mix other detergent and corrodent. It is used specially to clean the dirt, carbon, paint and adhesive matters accumulated in the diesel.


    Usage


    903 Carbon Removal Agent can filtrate the dirt.solute the grease, oil. paint and the matter not completed fired. 903 Carbon Removal Agent has the purpose of cleaning machine parts and completed machinery, for example, it is effective in cleaning the grease, emulsified rubber and epoxy paint.


    Here we suggest two methods.


    A. baptism method


    1. clean out the rubber enclosure, put the parts to be cleaned into the properly barrier, soak the surface with 903 Carbon Removal Agent.


    2. soaking time, it must wait all the dirt and grease solute or loose(as usual for 4-8 hours).


    a.when the dirt and grease is seriously dried, it needs shaking the solution now and then.


    b.when the dirt and grease is carbonated, heat the solution Upto55C-60c(130˙F-40˙F)


    Heating the agent to above 75℃ (165˙F) is forbidden.


    3.take it out of the cleaning basin, and wash it so as to clean the dirt on the parts, then dry it with cloth or blow it with compressed air.


    B detergent way


    It is available to clean the heavy machinery at site. use the paint bruxh to brush the dirty parts. When brushing remember dipping the agent usually. After the cleaning, dry it with
    cloth. Detailed cleaning procedure subjects to the site condition and can be determined be the engineer.


    Attention


    When handlingweor eye-protector and plastic gloves. Avoid breathing the agent longer time. Immediately wash with water if contact the agent. If necessary send to hospital for further
    assistance.


    Packing


    903 Carbon Removal Agent is always packed into 25 Liter small drum


    Storage
    亚洲国产精品久久艾草