•  
    您好!歡迎來到我們的網站
    鎮江百靈船舶用品有限公司??
    24小時服務熱線:
    20年生產循環水處理
    0511-85728888
    為廣大用戶提供優質的產品和完善的服務
    Zhenjiang Bailing Ship Supplies Co., Ltd.?
    產品中心
    地址:鎮江市民營開發區
    公司網址:WWW.ZJBLCB.COM
    聯系電話:0511-85728888
    公司傳真:0511-85728028
    郵編:212111
    聯系我們
    你的當前位置為:
    白靈牌902B型空氣冷卻器清潔劑
        發布時間: 2019-08-05 09:18    



    902B型空氣冷卻器清潔劑


    主要特點
    902B有極強溶解力,特為清除船舶空氣冷卻器及換氣系統渦輪增壓器的污垢而配制,有防銹性、速度快、省力、可用于運行中噴洗,或在停機時不拆下清洗,能去除重油油垢、積炭、稀釋不易燃燒。產品在20~C比重1.12,剛值6.5-7。無色,本產品和德魯ACC—9屬同類產品。
    產品用途
    1、運行中清洗柴油機空氣冷卻器和換氣系統;
    2、可在停機不拆下清洗,采用手噴清洗法;
    3、可用浸泡或清洗柜清洗含積炭的零件;
    4、可清洗裝重油、燃油的油艙、油池。
    使用方法
    一,運行中噴洗法:
    1,將902B以25%水溶液噴入空氣冷卻器和渦輪增壓的空氣面;以10%水溶液噴入渦增壓器的廢氣面;
    2,將902B水溶液從投藥缸中從上升氣流噴入冷卻器或渦輪增器約10分鐘,再經過10分鐘后,用等數量的淡水噴洗乳化后的斑漬;
    3,用藥比例和次數按空氣冷動器的實際情況而定,一般初次以每24小時噴洗一次,以后按48小時噴洗一次,重復次數要視空氣冷卻器大小和積垢情況而定。
    二,停機時不拆下手噴清洗法:
    1、先拆開一個適當的空氣槽的檢查蓋及沖洗閥;
    2、用壓力手提噴槍將902B純原液噴淋冷卻器蜷喉;
    3、使902B藥劑滲透斑漬至少1小時,然后用高壓水槍沖洗松散的斑漬,經淡水沖洗后,即關上空氣冷卻
    器檢查蓋及排水閥。
    三、浸泡法:
    此法用于硬質積炭零件,將零件浸入902B純原液中,待斑漬破碎松散后,用水沖洗。
    注意事項
    用后需密封存放。


    902B Cleanser for Air Equipment 


    Main characteristics


    902B has the strong soluble ability, it is confectedespecially for cleaning the air cooler of ship and turbosupercharger of air exhauster system, and Is capable of dust-proof, high speed, energy saving, it can be used to clean the heavy oil dirt during operation. It is not easy to fire. The density of 902B is 1.12 at 20℃. PH value is 6.5-7.The product is of no color and same as ACC -9 produced by Germany.


    Applications


    1. it can clean the air cooler of idesel and exhauster system during operation.


    2. it adopts the manual spraying cleaning when the machine is not operated. Dismemberment of machine is not necessary.


    3.it can be used to clean the parts containing the accumulated carbon with soaking or cleaning capsule.
    4.it can clear away the oil tank and oil pool full of heavy oil or fuel.


    Usage


    1. sprinkling method in the operation


    1.1 sprinkle the water solution with 25%. of 902B to the air surface of air cooler and turbosupercharager. and sprinklethe water solution with 10% of 902B into dirty air surface.


    1.2 sprinkle the water solution of 902B from agent vessel into the cooler or turbosupercharger for about 10 minutes.


    1.3 the content of 902B and times are determined as per the real situation of air cooler, for the first time sprinkle one time each 24 hours, after whicdh sprinkle one time every 48 hours.
    the repeating times is as per the condiUons of dirt.
    2. Manual spraying when shutdown


    2.1 dismount one proper inspection cap and washingvalve.


    2.2 spray 902B to aTe cooler.


    2.3 After one hour use high pressure water to wash the dirt.


    Shut-off the inspection cap and the valve.


    3. Soaking method


    This method is available for the hard carbon accumulated part. Put the part into 902B liquid, and wash it after the hard dirt is loose.


    Attention


     


    sealed storage alter use.
    亚洲国产精品久久艾草